Please note that these instructions are to help build the KPPX body.

CLICK HERE to download the complete instructions with cable assembly.

1. Assemble Strain Relief (A) with the Rear Housing (B) by lining up the notches.

2. Align Pin Block (C) with Lower Body (D), insuring that the Solder Cup contacts are in back. Match up the grooves, so that both parts are properly aligned.

3. Push Pin Block (C) into Lower Body (D). You will hear it click when it snaps into place.

4. Crimp U Section of Lower Body (D) around cable.

5. Fit Plastic Ring (E) onto Lower Body (D), so that the plastic guides line up properly with the grooves.

6. Attach Upper Body (F) with Lower Body (D), aligning all tabs and slots.

7. Push Coil Spring (G) over Upper Body (F), holding the completed assembly in place.

8. Take Strain Relief (A) and Rear Housing (B) already assembled and attach with assembled body, lining up notches to insure proper alignment.

9. Take Forward Housing (H) and completed assembly and push together until is snaps into place.

10. Slide Forward Housing (H) back and forth to insure the connector is assembled properly